Where is this knock sensor located?

[spooldup]

Looking to find out where it's located and what wire i need to pull from it so i can run a test that i was told to do? What are the torque specs too. Thanks guys.

 

[ghettosled]

back of the block near distributor and oil pressure sender.

 

[sy2185]

In the upper left of here.
Jeremy
www.chitownsyty.com/gallery/view_photo.php?set_albumName=represent&id=acj

 

[spooldup]

will i notice it when i go to look for it?

 

[sy2185]

yeah, but it can be a bit of a bitch. Be sure to only torque it to specs and no tighter- there's some "goop" on the threads of the new one and it helps isolate the sensor from any harmonics, etc. Unless you tighten it so tight that all the gel stuff gets pushed out and the sensor's contacting the block. You can just see it in the top left of the pic.
Jeremy