Pushrod & Lifter Part #'s

[once again its on]

Need advise on the final (hopefully) parts for my motor-

1) Pushrods-good ones-hardened or whatever
2) Lifters-good ones

Matching up with a 412 Comp Cam and L35 heads.

Thanks,
Brian
hiwinds@netscape.net
'92 Ty 2112
12.5 @ 108 RIP Motor #1

 

[Richard Le]

Hey Brian,

I'm currently using stock hydraulic lifters, Comp Cams Magnum 5/16" diameter 7.200" long hardened pushrods, and Comp Cams self-aligned Magnum roller tip 1.6 ratio rocker arms. If you use the stock lifters, then I guess any 5/16" 7.200" long pushrods would work. I tried Comp Cams Pro Magnum roller rockers once, but they were too wide - they touched each other. I think Crane Cams full blown roller rockers for centerbolt valve covers would fit though.