Recent content by StuckinCincy

What kind of schematic are you looking for? I have the factory schematics that show the connectors labeled a,b,c,d etc with a # and color code (237 yellow/blk). Most will show you what it goes to, like the indicator and illumination lamps, etc., but the gauge cluster connectors just give the...

Also done.

Re: Heater box part # I've come across two numbers in the parts catalog '91 is listed as CASE, orifice & baffle cutoff #3053722 '92-93 is listed as CASE, BLO #52456642

Re: Distributor I just replaced my MSD for the second time. The spacing between the rotor and the coil terminal on the cap was too close, melted the button and rotor, and the module went bad again after less than 2000 miles. The first one didn't make it to 2000 miles either, but MSD did a...

Re: Anyone Getting This Message? I've been getting the last three days also. Along with this where the body of the message should be: Unable to add cookies, header already sent. File: /home/sytynet/public_html/forums/includes/class_core.php Line: 3243

Re: SUMMIT Discount 10% Coupons Re: SUMMIT Discount 10% Coupons PM sent

Re: stainless steel braided brake hoses (?) I have these on my Syclone. http://www.summitracing.com/parts/rus-672330?seid=srese1&gclid=CK-jx7j04MUCFYQ6aQodqXIAWQ

Re: What fuse to pull so it won't run I'd say any one of four. ECM A, ECM B, Fuel Pump or COIL (might be labelled IGN). You may want to replace it with a blown one so it looks normal.

Looking for a stock compressor housing, would prefer not to buy a complete turbo if possible. Thanks, Craig

Re: water cooled turbo plumbing question I believe that the water pump fitting is on the suction side, so it would draw the water from the intake side after it has been heated by the engine.

Re: Radiators...whats best? Already have it, just don't have the truck running yet. It does appear to be decent quality, I plan to have a couple of threaded spacers welded onto the tanks for mounting an electric fan setup.

Re: Radiators...whats best? I recently bought one of these. Haven't got the truck running yet, but looks like decent quality. http://www.shepherdautoparts.com/autoparts/all_aluminum_radiator/chevrolet/pickup_%28sbackspacetsplashseries%29/1991/w5HDmsOQw5vDmsK7w5rDkcOWw5LCosKi.htm They also...

Re: G-body door seals Re: G-body door seals PM sent

Re: Need new turbo center cartridge Thanks , but I actually ordered a new center section from a Kinugawa distributor in California about a week ago.

Thanks for the info. I've been looking at kinugawa, but they don't list a stock replacement. I just talked to one of their guys that says their 20G center assemblies will fit inside the stock turbine and compressor housings. I plan to place my order in the next day or so.